Part of the  

Chip Design Magazine


About  |  Contact



Using Power Aware IBIS v5.0 Behavioral IO Models To Simulate Simultaneous Switching Noise

Typically simultaneous switching noise (SSN) transient simulations require significant CPU and RAM resources. A prominent factor affecting both CPU and RAM resource requirements is the number of MOSFET models included in the post layout extracted IO netlists. By replacing the IO netlists with power aware IBIS v5.0 behavioral models, both the CPU and RAM resource requirements are dramatically reduced. A comparison of several SSN transient simulations whereby the aggressor frequency is sweep across a wide frequency range is shown. The resultant victim waveforms will clearly demonstrate that each SSN transient simulation using post layout extracted IO netlists requires days to run compared to just mere minutes using power aware IBIS v5.0 behavioral models. Most notably, there is no significant loss in accuracy. In fact, in many cases, there is an increase in accuracy due to convergence issues associated with post layout extracted IO netlists. The power aware IBIS v5.0 behavioral models offer both dramatically faster transient simulation times and lower memory requirements. Improvements to these two key metrics without sacrificing accuracy, allows for more aggressive and accurate signal and power integrity analysis than has previously been possible.

To view this paper, click here.

Tags: , ,

Leave a Reply

Extension Media websites place cookies on your device to give you the best user experience. By using our websites, you agree to placement of these cookies and to our Privacy Policy. Please click here to accept.